Packard 66071 Goodman Draft Inducer Blower (2.8 Amps, 120V, 3000 RPM) Inducer Motor

The Packard 66071 Goodman Draft Inducer Blower (2.8 Amps, 120V, 3000 RPM) Inducer Motor is a Packard inducer motor for HVAC repair and replacement work. Use it when the part number 66071 and the listed specifications match the equipment being serviced.

Note: This is an aftermarket replacement part, please confirm compatibility with your original manufacturer part number Specifications: Speeds: 1 Volts: 120 Amps: 2.8 Rotation: CCWSE RPM: 3000 Bearings: Ball Diameter (In.): C-Frame Hertz: 60 Locked Rotor Amps: 3.7 Type: Shaded Pole

Key Specs

• Type: Shaded Pole
• Voltage: 120v
• RPM: 3000
• Product Type: Inducer Motor

Expert Verdict

Reviewed by the SuperArbor Pro Desk: choose this part when the existing component label and unit documentation match 66071 and the spec set above. It is best suited for targeted HVAC service repairs where exact fitment matters more than broad universal compatibility.

FAQs

What is the Packard 66071 used for?

It is a inducer motor for compatible Packard HVAC equipment. Match the part number 66071 and the equipment service literature before ordering or installing.

Which specs should I verify before purchase?

Verify the spec set shown for this part: Type: Shaded Pole; Voltage: 120v; RPM: 3000; Product Type: Inducer Motor. The replacement should match the existing component and the unit documentation.

Does the electrical rating need to match exactly?

Yes. Confirm voltage rating 120v against the failed component label. Do not substitute a different rating unless the equipment manufacturer allows it.

Is this an OEM-style replacement part?

Use it as a direct replacement only when Packard documentation lists 66071 or an approved equivalent for the unit being serviced.

Who should install this HVAC component?

A qualified HVAC technician should install and test the inducer motor. Disconnect power first, follow lockout procedures, and confirm safe operation after replacement.

Safety and Installation Notes

Disconnect power before service. HVAC electrical and combustion-related components should be installed and tested by a qualified technician. After installation, confirm wiring, mounting, airflow or fluid routing as applicable, and normal system operation.